Required - TTE - 3192 - Melt Pressure Systems

The CT style melt pressure transducer, is the classic melt pressure/transducer design. The CT style melt pressure transducer comprises a 6" rigid stem, along with 18" of flexible capillary, for optional thermal isolation.

General Specifications:
Mechanical:
- Pressure range: 0-1,500 psi to 0-15,000 psi.
- Metric ranges available
- Mounting: 1/2 -20 UNF thread
- M18 *1.5 available
- Mounting torque: 500 inch pounds maximum
- Diaphragm material: 15-5 PH stainless steel
- Overload capacity: 2 times FSO
- Temperature range: Diaphragm 750 Degree F, Electronics 225 Degree F
- Accuracy: General purpose <0.5 percent FSO
- Laboratory: <0.25 percent FSO
- Repeatability: Better than .15 percent FSO

Electrical:
- Type: Bonded strain gage 4 leg wheat stone bridge
- Bridge resistance: 350 Ohm +/- 5 percent
- Connector: 6 pin Bendix type
- Output: 3.3mV/Volt, 4-20 mA or 0-10 Vdc
- Excitation voltage: mV/Volt - 10 Vdc, 4-20 mA 24 Vdc, 0-10 Vdc and 24 Vdc
- Internal calibration: 80 percent of full scale output
- Insulation resistance: 1,000 Mohms at 50 Vdc
- Interconnecting cable: 25 inch with mating connector

(For picture, please see next page)

For More Details Contact:
Dydac Controls
Mr. Sushil Zarabi
Tel.: 011 22612177
Mobile: +91-9212027999
E-mail: dydcon@yahoo.com